Create a Route-Map

You can create a route-map, that evaluates packets and specifies actions to be performed on them.

About this task

Note the following naming conventions for name identifiers:

The name cannot exceed 64 characters.
The name must start with an alphabet character or an underscore.
The name must contain alphanumeric characters and special characters (underscores, hyphens, or periods).
The following reserved keywords cannot be used as name identifiers: all, ingress-group, egress, egress-group, match, list, access-list, route-map, and listener-policy.

Note

Sequence ID is required when you create a route-map; it defines the order in which it is to be processed (see the Extreme 9920 Software Command Reference, 21.2.2.0 for more information).

When you create a route map, you associate it with an egress-group using the set command.

Procedure

Enter the Config mode.
```
device(config)# 
```

Create a route map.

device(config)# route-map noc_traffic 10
device(config-route-map)# match ip access-list v4_external
device(config-route-map)# set egress-group netscout
device(config-route-map)# end
device#

Verify that the egress is created.

device# show route-map all
  rmap1 10
  egress-group egg123